How to test NAT translation on Palo Alto Firewall

Similar to firewall policy test on Palo Alto, use the following command to test which NAT translation policy is matched.

 > test nat-policy-match
 + destination        destination IP address
 + destination-port   Destination port
 + from               from
 + ha-device-id       HA Active-Active device ID
 + protocol           IP protocol value
 + source             source IP address
 + source-port        Source port
 + to                 to
 + to-interface       Egress interface to use
   |                  Pipe through a command
   <Enter>            Finish input